Waterloo student builds 92%-LEGO 3D printer for $173, wins trip to RepRap Festival
University of Waterloo Mechatronics student Adam Turaj designed an open-source 3D printer called "Studprint," built almost entirely from classic LEGO bricks rather than Technic parts, totaling $173.35 with just $30 spent on LEGO pieces. The project was submitted to Hack Club's Infill challenge, which offered a $350 grant and a trip for makers who built working 3D printers and printed a benchy test model, earning Turaj a flight to the Rocky Mountain RepRap Festival 2026 where he met Prusa CMO Zack Freedman and showcased the printer to thousands of attendees.
GoKawiil's interpretation of the reporting above, not reported fact.
The project shows how accessible 3D-printer design has become, with hobbyists able to combine cheap, widely available parts like LEGO bricks with standard open-source electronics such as the BTT SKR Pico and NEMA 17 motors to produce a functional machine for under $200. Hack Club's grant program suggests an effort to lower the barrier for young engineers entering DIY hardware design, which could encourage more unconventional, low-cost builds in the maker community.
- Studprint costs $173.35 to build, with 92% of its parts being standard LEGO bricks.
- The printer uses off-the-shelf electronics including a BTT SKR Pico board, Raspberry Pi Zero 2 W, and Mean Well power supply.
- The build was created for Hack Club's Infill challenge, earning Turaj a trip to the Rocky Mountain RepRap Festival 2026.
LEGO Classic Creative Brick Box — If this LEGO 3D printer build has you itching to experiment with your own mechanical contraptions, a big box of classic LEGO bricks is the perfect starting point. It gives you the raw studs and plates needed to prototype gears, frames, and structural supports just like Turaj did in Studprint.4
See LEGO Classic Creative Brick Box on Amazon → Affiliate link — we may earn a commission on purchases, at no extra cost to you. Product picked by AI based on this article; it is not a tested recommendation.Source: tomshardware.com — Jhet Borja, 2026-11-14
Published there as: “Mechatronics student builds 3D printer made from 92% LEGO for less than $180”
Read the original report → The summary and analysis above are GoKawiil's own, written from reporting by the source above. Facts and quotes belong to the original publisher.